43
5
MEMORY OPERATION
■ Memory channel programming
Memory channel programming can be preformed ei-
ther in VFO mode or in memory mode.
•Programming in VFO mode
q Set the desired frequency and operating mode in
VFO mode.
w Push [Y]/[Z] several times to select the desired
memory channel.
- Memory channel screen is convenient for selecting the
desired channel.
- Memory channel contents appear in the memory chan-
nel readout (below the frequency readout).
- “--.---.--” appears if the selected memory channel is a
blank channel (and does not have contents).
e Push [MW] for 2 sec. to program the displayed fre-
quency and operating mode into the memory
channel.
[EXAMPLE]: Programming 7.088 MHz/LSB into
memory channel 12.
•Programming in memory mode
q Select the desired memory channel with [Y]/[Z] in
memory mode.
- Memory channel contents appear in the memory chan-
nel readout (below the frequency readout).
- “--.---.--” appears if the selected memory channel is a
blank channel (and does not have contents).
w Set the desired frequency and operating mode in
memory mode.
- To program a blank channel, use direct frequency entry
with the keypad or memo pads, etc.
e Push [MW] for 2 sec. to program the displayed fre-
quency and operating mode into the memory
channel.
[EXAMPLE]: Programming 21.280 MHz/USB into
memory channel 18.
Push for 2 sec.
To Next Page
Loading...
