Icom IC-756PROIII - D about CW Reverse Mode; D Convenient Functions for Transmit; D CW Side Tone Function

36
4
RECEIVE AND TRANSMIT
DD
Convenient functions for transmit
•Break-in function (p. 67)
➥ Push [BK-IN] several times to select the break-in
OFF, semi break-in and full break-in.
•“BK-IN SEMI” or “BK-IN FULL” appears when the
semi break-in or full break-in function is set to ON, re-
spectively.
DD
About CW reverse mode
CW-R (CW Reverse) mode receives CW signals with
a reverse side CW carrier point like that of LSB and
USB modes.
Use when interfering signals are near a desired signal
and you want to change the interference tone.
q Push [CW/RTTY] once or twice to select CW
mode.
w Push [CW/RTTY] for 1 sec. to select CW or CW-R
mode.
• Check the interfering tone.
Push
for 1 sec.
BFO
CW-R mode (USB side)
BFO
Desired signal
CW mode (LSB side)
Interference
Desired signalInterference
CW/RTTY
[CW/RTTY]
4
DD
CW side tone function
When the transceiver is in the receive condition (and
the break-in function is OFF— p. 67) you can listen to
the tone of your CW signal without actually transmit-
ting.
This allows you to match your transmit signal exactly
to another station’s. This also convenient for CW
practice.
➥ Push [EXIT/SET] for 1 sec. then [(F-1)LEVEL] to
enter level set mode. Select an item with [(F-
1)
YY
]/[(F-2)
ZZ
] then rotate the tuning dial to adjust
the side tone level.
Tuning dial
[EXIT/SET] [(F-1)Y] [(F-2)Z]