70
6
FUNCTION FOR TRANSMIT
6
■ Monitor function
The monitor function allows you to monitor your trans-
mit IF signals in any mode through the speaker. Use
this to check voice characteristics while adjusting
SSB transmit tones. (p. 95) The CW side tone func-
tions regardless of the [MONITOR] switch setting.
q Push [MONITOR].
•The indicator (in [MONITOR] switch) lights when the
monitor function is ON.
w Push [EXIT/SET] several times to close a multi-
function screen, if necessary.
e Push [EXIT/SET] for 1 sec. then [(F-1)LEVEL] to
enter level set mode.
r Push [(F-1)
YY
] or [(F-2)
ZZ
] to select the monitor
level item.
t Adjust monitor gain using the tuning dial.
•Pushing [(F-3)DEF] for 1 sec. sets the selected item to
the default value.
y Push [EXIT/SET] twice to exit level set mode.
•Use headphones to prevent feedback.
•Set the transmit tone settings to the 0 dB positions
to check the unaltered characteristics of transmit-
ter or microphone.
To Next Page
Loading...
