86
9
SCANS
9
■ Select memory scan operation
q Push [EXIT/SET] several times to close a multi-
function screen, if necessary.
w Select memory mode.
e Push [(F-5)SCAN] to select the scan screen.
r Set [RF/SQL] open or closed.
• See p. 83 for scan condition.
•If the [RF/SQL] control function is set as “AUTO,” the
squelch is always open in SSB, CW and RTTY modes.
See pgs. 2, 30, 99 for details.
t Push [(F-1)MEMO] to start the memory scan.
• Decimal points blink while scanning.
y Push [(F-3)SELECT] to start select memory scan;
push [(F-3)SELECT] again to return to memory
scan, if desired.
u When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
i To cancel the scan, push [(F-1)MEMO].
2 or more memory channels must be designated
as select memory channels for select memory
scan to start.
■ Setting select memory channels
q Push [EXIT/SET] several times to close a multi-
function screen, if necessary.
w Select memory mode.
e Push [(F-5)SCAN] to select the scan screen.
r Select the desired memory channel to set as a se-
lect memory channel.
t Push [(F-3)SELECT] to set the memory channel
as a select memory or not.
y Repeat steps r to t to program another memory
channel as a select memory channel, if desired.
u Push [EXIT/SET] to exit the scan screen.
Select memory channels can also be set in the
memory channel screen. (p. 78)
To Next Page
Loading...
Need help?
General
