39
4
RECEIVE AND TRANSMIT
DD
Memory keyer send screen
Pre-set characters can be sent using the keyer send
menu. Contents of the memory keyer are set using
the edit menu.
•Transmitting
q Push [EXIT/SET] several times, if necessary.
w Push [CW/RTTY] to select CW mode.
e Push [(F-3)KEYER] to select the memory keyer
screen.
r Push [TRANSMIT] to set the transceiver to trans-
mit, or set the break-in function ON (p.67).
t Push [(F-1)M1] – [(F-4)M4] momentarily to trans-
mit the contents one time; push these keys for 1
sec. to transmit the contents repeatedly.
• “M1”–“M4” are highlighted while transmitting.
•“ ” appears while transmitting repeatedly.
•
Set the repeat interval of the memory keyer to 1–60 sec.
(1 sec. steps). See p. 42 for keyer set mode.
•To count down the contact number, push [
(F-5)–1].
For your information
When an external keypad is connected to the pin 3
and pin 7 of the [MIC] connecter, the programmed
contents, M1–M4, can be transmitted without open-
ing the memory keyer screen.
See page 104 for details.
y Push [EXIT/SET] twice to exit the memory keyer
screen.
To Next Page
Loading...
