10
MAINTENANCE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
10-4
Step 3� Loading the setting data into the sub
transceiver�
1. Open the LOAD SETTING screen.
» SET > SD Card > Load Setting
2. Touch the file to load
3. Touch “Select.”
L If you want to load all the contents on the LOAD
OPTION screen, touch “ALL” and go to step 6.
L If you want to load only the repeater list, touch
“Repeater List Only” and go to step 6.
4.
Touch the loading options. (Example: CI-V Address)
• “✓” is displayed left side of the selected option.
L The Set mode settings and Memory channel
contents are always loaded.
5. Touch “<<Load>>.”
6. Touch [YES] or [NO].
• “Load le ?” is displayed.
L When you touch [YES], the skip settings of the
repeater list are retained.
L When you touch [NO], the skip settings of the
repeater list are cleared.
7. Touch [YES].
• After the loading ends, “COMPLETED! Restart the
IC-9700.” is displayed.
L When you select “REF Adjust” in step 4, “The new
"REF Adjust" setting will be saved” is displayed.
8. Turn OFF the transceiver power, then turn it ON
again to restart the transceiver.
Cloning (Continued)
To Next Page
Loading...
