Icom IC-F3400D

12
USER SETTINGS
12-3
Setting the Key-touch Beep level
<Key operation>
Portable: For the Non-display types
1. Turn OFF the transceiver.
2. Set [Selector] to any channel other than Channel
16.
3. While holding down [F3], turn ON the transceiver.
Continue holding down [F3] for about 3 seconds.
• 2 beeps sound.
• The transceiver enters the Key-touch Beep level Set
mode.
4. Push [F2] or [F3] to set the Key-touch Beep level.
InformationL
• The setable range is 1 ~ 5, 1 (Linked) ~ 5 (Linked) or
OFF.
• When you select a Linked option, the beep level is
adjustable by rotating [VOL].
• A beep sounds after pushing [F2] or [F3]. An error
beep sounds if you try to exceed the setable range.
5. Turn OFF the transceiver, then turn it ON again to
exit the Key-touch Beep level Set mode.
You can set the Key-touch Beep level.
A beep sounds when you operate a key.
<Menu operation>
Portable: For the Ten-key and the Simple key types
Mobile: For the LCD types
( Menu > Utility > Key-touch Beep Lv)
1. Push [Menu] to display the Menu screen.
2. Push [Left] or [Right] to select “Utility,” then
push
[OK].
3. Push [Up] or [Down] to select “Key-touch Beep
Lv,” then push [OK].
4. Push [Up] or [Down] to set the Key-touch Beep
level, then push [OK].
L The setable range is 1 ~ 5, 1 (Linked) ~ 5 (Linked) or
OFF.
L When you select a Linked option, the beep level is
adjustable by rotating [VOL].
5. Hold down [Back] for 1 second to return to the
standby screen.
Setting order of the Key-touch Beep level
2
5
4
3
OFF
1
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)
: Push [F2]
: Push [F3]
[VOL]
[F2]
[F3]
[Selector]
Previous view