12
USER SETTINGS
12-5
Setting the Ringer level
<Key operation>
Portable: For the Non-display types
1. Turn OFF the transceiver.
2. Set [Selector] to Channel 16.
3. While holding down [F3], turn ON the transceiver.
Continue holding down [F3] for about 3 seconds.
• 2 beeps sound.
• The transceiver enters the Ringer level Set mode.
4. Push [F2] or [F3] to set the Ringer level.
InformationL
• The setable range is 1 ~ 5, 1 (Linked) ~ 5 (Linked) or
OFF.
• When you select a Linked option, the Ringer level is
adjustable by rotating [VOL].
• A beep sounds after pushing [F2] or [F3]. An error
beep sounds if you try to exceed the setable range.
5. Turn OFF the transceiver, then turn it ON again to
exit the Ringer level Set mode.
You can set the Ringer level.
Rings sound when receiving a call.
<Menu operation>
Portable: For the Ten-key and the Simple key types
Mobile: For the LCD types
( Menu > Utility > Ringer Lv)
1. Push [Menu] to display the Menu screen.
2. Push [Left] or [Right] to select “Utility,” then
push
[OK].
3. Push [Up] or [Down] to select “Ringer Lv,” then
push [OK].
4. Push [Up] or [Down] to set the Ringer level, then
push [OK].
L The setable range is 1 ~ 5, 1 (Linked) ~ 5 (Linked) or
OFF.
L When you select a Linked option, the Ringer level is
adjustable by rotating [VOL].
5. Hold down [Back] for 1 second to return to the
standby screen.
2
5
4
3
OFF
1
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)
: Push [F2]
: Push [F3]
Setting order of the Ringer level
[VOL]
[F2]
[F3]
[Selector]
To Next Page
Loading...
Need help?
General
