12
USER SETTINGS
12-4
Setting the Key-touch Beep level
<Key operation> (Continued)
Mobile: For the Segment types
1. Turn OFF the transceiver.
2. While holding down [F2] and [F3], turn ON the
transceiver. Continue holding down [F2] and [F3]
for about 3 seconds.
• 2 beeps sound.
3. Hold down [F1] for 1 second to enter the Set mode.
4. Push [F2] or [F3] to select the “A1” screen.
5. Push [Up] or [Down] to set the Key-touch Beep level.
InformationL
• The setable range is 1 ~ 5, 1 (Linked) ~ 5 (Linked) or
OFF.
• When you select a Linked option, the beep level is
adjustable by rotating [VOL].
• A beep sounds after pushing [Up] or [Down]. An error
beep sounds if you try to exceed the setable range.
6. Hold down [F1] for 1 second to exit the Set mode.
7. Turn OFF the transceiver, then turn it ON again to
normally operate it.
2
5
4
3
OFF
1
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)
: Push [Up]
: Push [Down]
Setting order of the Key-touch Beep level
F1 F2 F3
[Up]
[Down][F1] [F2] [F3]
[VOL]
Power key
To Next Page
Loading...
Need help?
General
