EasyManuals Logo

Icom IC-F3400D User Manual

Icom IC-F3400D
189 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #169 background imageLoading...
Page #169 background image
12
USER SETTINGS
12-11
Setting the VOX gain level
<Key operation>
Portable: For the Non-display types
1. Turn OFF the transceiver.
2. Set [Selector] to Channel 16.
3. While holding down [F1] and [F2], turn ON the
transceiver. Continue holding down [F1] and [F2]
for about 3 seconds.
2 beeps sound.
The transceiver enters the VOX gain level Set mode.
4. Push [F2] to increase, or push [F3] to decrease
the gain level.
L The setable range is 1 (minimum) ~ 10 (maximum).
L A beep sounds after pushing [F2] or [F3]. An error
beep sounds if you try to exceed the setable range.
5. Turn OFF the transceiver, then turn it ON again to
exit the VOX gain level Set mode.
You can set the VOX gain level to between 1
(minimum) and 10 (maximum). Higher values make
the VOX function more sensitive to your voice.
<Menu operation>
Portable: For the Ten-key and the Simple key types
Mobile: For the LCD types
( Menu > Functions > VOX Gain)
1. Push [Menu] to display the Menu screen.
2. Push [Left] or [Right] to select “Functions,” then
push [OK].
3. Push [Up] or [Down] to select “VOX Gain,” then
push [OK].
4. Push [Up] or [Down] to set the VOX gain level,
then push [OK].
L The setable range is 1 (minimum) ~ 10 (maximum).
5. Hold down [Back] for 1 second to return to the
standby screen.
[VOL]
[F1]
[F2]
[F3]
[Selector]
Mobile: For the Segment types
1. Turn OFF the transceiver.
2. While holding down [F2] and [F3], turn ON the
transceiver. Continue holding down [F2] and [F3]
for about 3 seconds.
2 beeps sound.
3. Hold down [F1] for 1 second to enter the Set
mode.
4. Push [F2] or [F3] to select the “A6” screen.
5. Push [Up] to increase, or push [Down] to decrease
the gain level.
L The setable range is 1 (minimum) ~ 10 (maximum).
L A beep sounds after pushing [Up] or [Down]. An error
beep sounds if you try to exceed the setable range.
6. Hold down [F1] for 1 second again to exit the Set
mode.
7. Turn OFF the transceiver, then turn it ON again to
normally operate it.
F1 F2 F3
[Up]
[Down][F1] [F2] [F3]
Power key
Previous view

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom IC-F3400D and is the answer not in the manual?

Icom IC-F3400D Specifications

General IconGeneral
BrandIcom
ModelIC-F3400D
CategoryTransceiver
LanguageEnglish

Related product manuals