Icom IC-M506 - Page 115

106
12
CONNECTIONS AND MAINTENANCE
e
End bolt
Locking nut
r
D MB-132 installation
Attach the clamps on either side of the transceiver with 2 q
supplied bolts. (M5 × 8 mm)
 •Makesurethattheclampsalignparalleltothetransceiverbody.
Tighten the end bolts on the clamps (clockwise) so that the w
clamps press firmly against the inside of the instrument
control panel.
Tighten the locking nuts (counterclockwise) so that the e
transceiver is securely mounted in position, as shown be-
low.
Connect the antenna and power cable, then return the in- r
strument control panel to its original place.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
w
e