Icom IC-M506 - D Receiving a Position Request Call

61
7
DSC OPERATION
Receiving a Position Request Call D
When a Position Request Call is received:
➥ The alarm sounds for 2 minutes.
➥ “RCVD POS REQUEST” appears. The backlight blinks for
2 minutes.
q Push [ALARM OFF] to stop the alarm and the blinking
backlight.
 •Evenifyoudonotpush[ALARMOFF],thealarmstopsafter2
minutes, and then the screen in step w is displayed.
w Push a softkey to select your desired action.
[IGN]
➥Push to ignore the Call and return to the normal operat-
ing mode.
  •ThetransceiverexitstheDSCmode.
  •The“ ” icon continues to blink and the Call is stored in the
Received Call Log.
[INFO]
➥Push to display the Received call information. (p. 65)
[ACK]
➥ Push to display the “POSITION REPLY” screen and
send a reply to the Call. (p. 47)
When “POSITION ACK” is set to “Auto,” the transceiver au-
tomatically replies to the Call. In that case, both the TX and
RX calls are stored in the Transmitted and Received Call
Logs.