Icom IC-M506 - D Transmitting a Position Reply Call

47
7
DSC OPERATION
New2001New2001
Transmitting a Position Reply call D
Transmit a Position Reply call when a Position Request call
is received.
When the “POSITION ACK” in DSC Settings is set to ‘Auto’
(p. 68), the transceiver automatically transmits a reply call
when receiving a Position Request call.
Quick Reply:
About Received call information:
•Push[IGN]toignorethecallandreturntothenormaloperating
mode.
•Push[BACK]toreturntothepreviousscreen.
•Push[ACK]togotothenextstep.
The Position Reply confirma- e
tion screen is displayed.
Push [CALL] to transmit the
reply call.
 •Push [EXIT] to return to the
normal operating mode.
While transmitting the reply r
call, the screen shown below
is displayed, and then re-
turns to the normal operating
mode.
q When a Position Request call
is received, alarm sounds
and the screen shown below
is displayed.
Push [ALARM OFF] to stop
the alarm.
 •Even if you do not push
[ALARM OFF], the alarm stops
after 2 minutes, and then the
screen in step w is displayed.
w Push [ACK].
 •Push [IGN] to ignore the call
and return to the normal oper-
ating mode.
 •Push[INFO]todisplaythePo-
sition Request call information.