Icom IC-M506 - Received Call Log

65
7
DSC OPERATION
D Receiving a Test Acknowledgement Call
When a Test Acknowledgement Call is received:
The alarm sounds for 2 minutes. ➥
“Received ACK” is displayed. The backlight blinks for 2 ➥
minutes.
Received Call log ■
The transceiver automatically stores up to 50 distress mes-
sages and 50 other messages, and they can be used as a
supplement to your logbook.
•Whileinthenormaloperatingmode,the“ ” icon blinks in the up-
per right corner of the LCD when there is an unread DSC message.
Distress message D
Push the softkey [LOG] to enter “RCVD CALL LOG” in the q
DSC CALLS menu, or you can enter it through the Menu
screen.
MENU ➪ DSC ➪ Received Call Log
(Push [MENU]) (Select icon) (Rotate dial, then push [ENT].)
Push [ w Y]/[Z] to select “Distress,” then push [ENT].
 •TheDistressmessagesarestoredin“Distress.”
 •The“ ” icon appears when there are unread DSC messages.
 •The“ ” icon appears when there are no unread DSC mes-
sages.
 •NoiconappearswhentherearenoDSCmessages.
•Push[BACK]toreturntothepreviousscreen.
•Push[EXIT]toreturntothenormaloperatingmode.
q Push [ALARM OFF] to stop
the alarm and the blinking
backlight.
 •Evenifyoudonotpush[ALARM
OFF], the alarm stops after 2
minutes, and then the screen in
step w is displayed.
w Push [EXIT] to return to the
normal operating mode.
 •The transceiver exits the DSC
mode.
 •“ ” continues to blink and the
Call is stored in the Received
Call Log.