Icom IC-M506 - NMEA2000 Unit Main Unit Board Layout; NMEA2000 Unit Connect Unit Board Layout; AIS Unit Connect Unit Board Layout

26
7
DSC OPERATION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
When no GPS receiver is connected, and both position
and time have been manually programmed, the screen
as shown below appears. Edit your latitude and longitude
position and UTC time as follows:
Push [CHG], then edit your latitude and longitude posi- ➥
tion and UTC time.
 •Selectadesirednumberusing[Y]/[Z]/[Ω]/[≈].
 •Push[ENT]ordialtosetit.
 •Tomovethecursor,rotatedialorselecteitherarrow,“←” or
“→,” then push [ENT] or Dial.
 •SelectN(Northlatitude)orS(Southlatitude)whenthecur-
sor is on the ‘N’ or ‘S’ position.
 •SelectW (Westlongitude) or E (East longitude) when the
cursor is on the ‘W’ or ‘E’ position.