How to turn on beep sounds on an Icom IC-M72?
If your Icom Transceiver is not making any beeping sounds, the beep tones may be turned off. Go to the SET mode and set the beep tones to ON (Fix Beep/User Beep).
Why doesn't the scan start on my Icom IC-M72?
If your Icom Transceiver scan does not start, it may be because “TAG” channels are not programmed. Set the desired channels as “TAG” channels.
Why is my Icom Transceiver transmitting continuously with VOX enabled?
If your Icom Transceiver is transmitting continuously when using the VOX function, it could be due to loud ambient noise. Try pushing [ ] and [H/L•LOCK] to deactivate the VOX function. You can also set the VOX gain to a lower sensitivity value.
Why can't I transmit or select high power on my Icom IC-M72?
If you can't transmit or select high power on your Icom Transceiver, it could be due to several reasons: * You may be on a channel that only supports low power or receive-only; try changing channels. * The battery might be low; recharge it. * The battery could be overcharged; verify the voltage is correct. * The output power might be set to low; push [H/L•LOCK] to select high power.
What to do if the “CHARGE” comment blinks on my Icom IC-M72?
If your Icom Transceiver displays a blinking “CHARGE” comment, it means the connected battery is depleted and needs to be recharged.
Why is there no sound coming from my Icom IC-M72 Transceiver speaker?
If your Icom Transceiver speaker isn't producing sound, there could be several reasons: * The squelch level might be set too high; try adjusting it to the threshold point. * The volume could be too low; rotate the [VOL] knob to increase it. * If the speaker has been exposed to water, press and hold both [16•9] and [H/L•LOCK] to drain it. * If water has entered the [SP MIC] connector, make sure to dry it thoroughly.
How to unlock my Icom IC-M72?
If the lock function is activated on your Icom Transceiver, push [H/L•LOCK] for 1 second to cancel the function.
How to unlock the channel on my Icom Transceiver?
If the displayed channel on your Icom Transceiver cannot be changed, the lock function may be activated. Push [H/L•LOCK] for 1 second to cancel the function.
Discusses FCC RF exposure limits and compliance guidelines for human exposure.
Explains potential interference and areas to avoid radio operation.
Step-by-step guide for making a distress call on Channel 16.
Explains monitoring of distress and other channels.
Advises against connecting to AC, improper antenna use, and extreme temperatures.
Details on ship station and operator licenses needed for operation.
Details operation of volume, PTT, monitor, channel, and power/lock keys.
Details various indicators like Monitor, Dual/Tri-watch, VOX, Lock, Busy, etc.
How to select Channel 16 for distress and Channel 9 as a call channel.
Covers powering on, setting volume/squelch, selecting channels, and transmitting.
How to program call channels and activate the key lock function.
Explains priority scan and normal scan functionalities.
Procedure to enter SET mode and select items.
Warnings about misuse, handling, temperature, and disposal of batteries.
Guidelines for charging the battery pack safely and correctly.
Lists common issues like no power, no sound, and their solutions.
General| Brand | Icom |
|---|---|
| Model | IC-M72 |
| Category | Transceiver |
| Language | English |
To Next Page
