8
3
FREQUENCY AND CHANNEL SETTING
■ Selecting a memory channel
q Push [V/M] once or twice to se-
lect memory mode.
•“X” appears when a memory
channel is selected.
w Rotate [DIAL] to change the indi-
cated memory channel.
•Only programmed memory chan-
nels can be selected.
•Rotating [DIAL] while pushing
[FUNC] to change the channel in 10
channel steps.
■ Lock function
The lock function prevents accidental frequency changes and
accidental function access.
➥Push [FUNC] + [
(CALL)LOCK] to toggle the lock function ON
and OFF.
•[POWER], [VOL], [SQL] and [PTT]
can still be accessed while the lock
function is ON (default).
•Accessible switches can be set to 1
of 4 groups in expanded set mode.
See p. 31 for details.
■ RIT function
To compensate for the off frequency of a transmitting station,
the transceiver has receive incremental tuning for receiving
frequencies above 835 MHz.
The receive incremental tuning (RIT) shifts only the receive
frequency within approx. ±5 kHz at 850 MHz and ±7 kHz at
1300 MHz.
q Set an operating frequency above 835 MHz.
w Push [FUNC] + [BAND] to turn the RIT function ON.
•“RIT” appears.
e While pushing [FUNC], rotate [DIAL] to adjust the shift fre-
quency.
•–5 to 5 appear at the memory chan-
nel readout while setting the shift
frequency.
r To cancel the function, push
[FUNC] + [BAND] to turn the RIT
function ON.
•“RIT” disappears.
While the RIT function is in use, the dial select step cannot
be used. (pgs. 7, 29)
To Next Page
Loading...
Need help?
General
