12
5
MEMORY/CALL CHANNELS
■ General
The transceiver has 200 memory channels in 2 banks and 2
call channels for storage of often-used frequencies.
D Memory/call channel contents
The following information can be programmed into memory
or call channels:
•Operating frequency (p. 7)
•Receive mode (p. 11)
•Tuning step (p. 7)
•Duplex direction (DUP or –DUP) with an offset frequency
(pgs. 22, 24)
•Subaudible tone encoder or tone squelch ON/OFF (pgs.
23, 26)
•Subaudible tone and tone squelch frequencies (pgs. 23,
26)
•Scan skip setting (p. 18)
■
Programming during selection
q Select VFO mode with [V/M].
w Set the desired frequency:
➥ Select the desired band with [BAND].
➥ Set the frequency using [DIAL].
➥Set other data (e.g. offset frequency, duplex direction,
subaudible tone frequency, etc.), if required.
e Push [FUNC] + [V/M] momentarily to indicate memory
channels.
•Do not hold [FUNC] + [V/M] for more than 0.5 sec., otherwise the
memory channel will overwrite the selected memory channel.
r Rotate [DIAL] to select the desired channel.
•Call channels (C1, C2) and VFO (VF), as well as regular memory
channels, can be programmed in this way.
•Rotate [DIAL] while pushing [FUNC] to select a memory channel
in 10 channel steps.
t Push [FUNC] + [V/M] for 2 sec. to program.
To Next Page
Loading...
Need help?
General
