21
7
PRIORITY WATCH
■ Priority watch operation
DMemory/call channel watch and memory
scan watch
q Select VFO mode; then, set an operating frequency.
w Set the watching channel(s).
For memory channel watch:
Select the desired memory channel.
For memory scan watch:
Select memory mode; then, push [FUNC] + [Y] or [Z] mo-
mentarily to start memory scan.
For call channel watch:
Select the call channel by pushing [CALL].
e Push [V/M] for 2 sec. to enter set mode.
r Rotate [DIAL] until “PRIO” appears.
•“PRIO” disappears after 1 sec. and “OFF” and “PR” appear.
t While pushing [FUNC], rotate [DIAL] to select priority
watch ON or priority watch ON with alert.
y Push [V/M] to exit set mode and start the watch.
•The transceiver checks the memory
or call channel frequency every 5 sec.
•The watch resumes according to the
selected scan resume condition. (p.
18)
u Push [V/M] while the display
shows the VFO frequency to stop
the watch.
DVFO scan watch
q Select the desired memory channel to be watched.
w Push [V/M] to select VFO mode.
e Push [FUNC] + [Y] or [Z] momentarily to start full scan,
band scan or programmed scan. (p. 16)
r Push [V/M] for 2 sec. to enter set mode.
t Rotate [DIAL] until “PRIO” appears.
•“PRIO” disappears after 1 sec. and
“OFF” and “PR” appear.
y While pushing [FUNC], rotate
[DIAL] to select priority watch ON
or priority watch ON with alert.
u Push [V/M] to exit set mode and
start the watch.
•The transceiver checks the memory
channel frequency every 5 sec.
•The watch resumes according to the
selected scan resume condition. (p.
18)
i Push [V/M] while the display
shows the VFO frequency to stop
the watch.
To Next Page
Loading...
Need help?
General
