EasyManuals Logo

Icom IC-Q7A User Manual

Icom IC-Q7A
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
16
6
SCAN OPERATION
Full/band/programmed scan
q Select VFO mode with [V/M].
w Make sure the squelch is set to the threshold point.
Select automatic squelch (AUTO) or a level (19) where the
noise is muted. (p. 10)
e Select the desired scan range, if desired.
Select scan edges in set mode:
ALL for full scan, BAND for band scan or 0P”–“19P
for programmed scan. (see the next page)
r Push [FUNC] + [Y] or [Z] momentarily to start the scan.
Decimal point ashes while scanning.
•“P SKIP”flashes when the frequency skip function is turned ON.
(p. 19)
•“0P”–“19P flash to indicate which pair of scan edges is being
scanned.
To change the scanning direction, rotate [DIAL].
If the pocket beep function is activated, the transceiver automat-
ically selects the tone squelch function when a scan starts.
t To stop the scan, push [FUNC] + [Y] or [Z] again.
If the same frequencies are programmed into a pair of
scan edges, programmed scan does not start.
For programmed scan, scan edges must be programmed
in advance. Program scan edges into regular memory
channels and set the channels as scan edges. (p. 17)
Memory (bank) scan
q Select memory mode with [V/M].
w Make sure the squelch is set to the threshold point.
Select automatic squelch (AUTO) or a level (19) where the
noise is muted. (p. 10)
e Select the desired memory bank in set mode, if desired.
See below for details.
r Push [FUNC] + [Y] or [Z] momentarily to start the memory
scan or memory bank scan.
Decimal point ashes while scanning.
•“”flashes during memory bank scan.
To change the scanning direction, rotate [DIAL].
If the pocket beep function is activated, the transceiver automat-
ically selects the tone squelch function when a scan starts.
t To stop the scan, push [FUNC] + [Y] or [Z] again.
DMemory bank selection
q Push [V/M] for 2 sec. to enter set mode.
w Rotate [DIAL] until BNK SC appears.
e While pushing [FUNC], rotate [DIAL] to select the desired
memory bank.
•“OFF scans memories in both banks;
BANK0 scans memories in bank 0
only (ch 0 to 99); BANK1 scans
memories in bank 1 only (ch 100 to
199).
r Push [V/M] to exit set mode.
Memory bank 0
(Memory ch 0 to 99)

Table of Contents

Other manuals for Icom IC-Q7A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom IC-Q7A and is the answer not in the manual?

Icom IC-Q7A Specifications

General IconGeneral
BrandIcom
ModelIC-Q7A
CategoryTransceiver
LanguageEnglish

Related product manuals