EasyManuals Logo

Icom IC-T10 User Manual

Icom IC-T10
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
5
SET MODE
5-9
Initial Set Mode items
Voltage indication (Default: On)
Selects whether or not to display the battery voltage
while turning ON the transceiver.
OFF: The transceiver does not display the
battery voltage.
On: The transceiver displays the battery
voltage.
Auto low power (Default: OFF)
Selects whether or not to enable the Auto Low Power
function.
OFF: Turns OFF the function.
On: When the temperature goes

automatically sets the all output
power to low.
L High or Mid power are disabled.
Tone burst (Default: OFF)
Selects whether or not to enable the Tone Burst
function when using the Tone Squelch function.
OFF: When you transmit a signal that
superimposes the CTCSS tone, the
other stations may hear a short burst
of noise from their receiver, just after
you stop transmitting.
On: When you transmit a signal that
superimposes the CTCSS tone, the
function mutes the noise from being
heard in the other station receiver.
Earphone antenna (Default: OFF)
Selects whether or not to use the earphone antenna
for FM radio.
OFF: An earphone antenna is not used.
On: An earphone antenna is used.
Monitor (Default: PUSH)
Selects how to use the Monitor function.
PUSH: Hold down [MONI] to monitor
the frequency. Release to stop
monitoring.
HOLd: Push [MONI] momentarily to monitor
the frequency and push momentarily
again to cancel it.

Table of Contents

Other manuals for Icom IC-T10

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom IC-T10 and is the answer not in the manual?

Icom IC-T10 Specifications

General IconGeneral
BrandIcom
ModelIC-T10
CategoryTransceiver
LanguageEnglish

Related product manuals