BASIC OPERATION
3
7
■ Checking the installation
Before turning ON the power, be sure all the connec-
tions are complete. The checklist at right may be help-
ful for necessary confirmation.
CAUTION: Connect the scanner unit before turning ON
the power. Otherwise the magnetron inside the scanner
unit might be damaged.
DChecklist
q The four bolts securing the scanner unit must be
firmly tightened.
w Cabling must be securely attached to a mast or
mounting material, and must not interfere with the
rigging.
e Be sure waterproofing procedures are completed
on the system cable.
r The power connections to the battery must be of
the correct polarity.
t Be sure that the plugs at the rear of the display unit
have been connected correctly and securely.
(See page 23 for details.)
■ Turning power ON/OFF
1
(0.25)
T.VECT 6M
0.000NM
NM
CURS
SOG17.7KT
H UP
000.0˚T
HDG253.4˚T
EBL1
EBL2
MOB
VRM1
VRM2
CURS 34˚ 37.72N
13 5˚ 34.42E
STBY
IR
COMPASS
GPS
1
(0.25)
T.VECT 6M
0.000NM
NM
CURS
SOG17.7KT
H UP
000.0˚T
HDG253.4˚T
EBL1
EBL2
MOB
VRM1
VRM2
CURS 34˚ 37.72N
13 5˚ 34.42E
IR
COMPASS
GPS
0.45
REV *.*
ROM OK
RAM OK
q Push [POWER]/[ ] to turn ON the power.
• The initial screen appears and the magnetron warm up
time is counted down on the screen.
•
The magnetron inside the scanner unit warms up for 90
seconds.
• [POWER]/[ ] is disabled for 2 seconds after
the power is turned OFF.
w When the countdown is completed, the Standby
screen appears.
e Push [TX]/[ ] to start scanning and select
the Plan Position Indicator (PPI) screen.
• Targets and heading markers appear.
• The screen appears approximately 2 seconds after
turning ON the power, when ‘AUTO’ is selected in the
“TUNE” item of the VIDEO menu.
r Push [POWER]/[ ] to turn OFF the power.
To Next Page
Loading...
