Icom MR-1000RII - Bearing and Distance Measurement

14
4
DISTANCE AND DIRECTION MEASUREMENTS
■ Bearing and Distance measurement
This radar has two Electronic Bearing Lines (EBL) to
indicate the target direction from your ship or a target.
DUsing the EBL and VRM
3/4
TVECT
3M
1141NMNM
CURS
SOG 00
km/h
H UP
3240
R
HDG
IR
3151 ˚T
2471 ˚T
WPT 34
0503NM
0359NM
EBL1
EBL2
VRM1
VRM2
POSN
EBL1
VRM1
EBL2
EBL1
readout
EBL2
readout
VRM2
VRM1 readout
VRM2 readout
q Push [p] [q] [t] [u] to move the cursor onto the
desired target.
w Push [EBL1 (VRM1)]/[ ] to display the
EBL1 and VRM1.
• Push [t] [u] to rotate the electronic bearing line.
• Push [u] to rotate clockwise and push [t] to rotate
counterclockwise.
• Push [p] [q] to increase or decrease the variable range
marker ring size.
• The EBL1 and VRM1 readouts indicate the target bear-
ing and distance.
• The EBL readouts indicate the target bearing;
0 to 360°R : Relative direction, when ‘360°R’ is se-
lected in the EBL/PI item of the FUNC-
TION menu. (See page 5)
P/S 0 to 180° : Bow direction, when ‘PT/SB’ is selected
in the EBL/PI item of the FUNCTION
menu. (See page 5)
0 to 360°T* : True or magnetic bearing, when select-
ing ‘TRUE’ in the EBL/PI item of the
FUNCTION menu. (See page 5)
*Bearing data is required. (p. 38)
e Push [EBL1 (VRM1)]/[ ] to clear EBL1
and VRM1.
• Cursor remains on the display.
r Push [p] [q] [t] [u] to move the cursor onto the
desired target.
t Push [EBL2 (VRM2)]/[ ] to display
EBL2 and VRM2 on the display.
• When EBL1 and VRM1 are displayed, the beginning
of EBL2 and VRM2 appears at the intersection point of
EBL1 and VRM1.
• EBL2 and VRM2 disappear when [EBL1 (VRM1)]/
[
] is pushed.
y To clear EBL1 and VRM1, push [EBL1 (VRM1)]/
[ ].