Icom MR-1000RII - 14 External Data List

The following external bearing, speed, position and waypoint data is (are) required , when you use the radar
functions.
*
1
OG; Over ground, TW; Through the water
*
2
NMEA1 and NMEA2 connectors; See page 23
• “HDT”, “HDM”, “RMC”, “GGA”, “GLL”, “VTG”, “WPL”, “GNS” and “BWC” are SENTENCES of the NMEA0183.
• If BRG INPUT is set to “GPS”, “RMC” of NMEA2 connector or COG (Course Over the Ground) of “VTG” a bow it
receives as a direction, even if there is no direction information (compass etc.) in NMEA1 connector, the screen
display of the North rise etc. is possible.
However, direction accuracy falls when the speed of a ship is set to 2 knots or less, or when exceeding 3 kts a
bow it does not receive as direction data. Moreo, the inuence of measurement position accuracy or a current an
actual bow it may differ from a direction.
14
38
EXTERNAL DATA LIST
EXTERNAL DATA INPUT
NMEA1*
2
NMEA2*
2
“HDT”, “HDM” “RMC”, “GGA”, “GLL”, “VTG”, “WPL”, “BWC”, LOG, “GNS”
N+1, AUX
FUNCTION DISPLAY BEARING SPEED POSITION WAYPOINT
HEAD UP HU
COURSE UP CU Required
NORTH UP NU Required
TRUE MOTION OG*
1
TM Required “RMC”, “GGA” or “GLL”, “GNS”
TW*
1
TM Required LOG
SPEED DISPLAY OG*
1
SOG “RMC” or “VTG”
TW*
1
STW LOG
HEADING BEARING HDG Required
WAYPOINT WPT Required “RMC”, “GGA” or “GLL”, “GNS” “WPL” or “BWC”
OWN VECTOR OG*
1
Required “RMC” or “VTG”
TW*
1
Required LOG
MOB MOB Required “RMC”, “GGA” or “GLL, “GNS”
ATA OG*
1
ATA Required “RMC” or “VTG”
TW*
1
ATA Required LOG
VRM/PI/WPT/MOB estimated OG*
1
“RMC” or “VTG”
time of arrival TW*
1
LOG
MAGNETIC VARIATION (AUTO) “RMC” or “VTG”