How to fix a blank LCD screen with a RED LED on an ICS GPS?
If the LCD screen of your ICS GPS is blank but the RED LED is on, it might be due to the green wire being incorrectly connected to 12V. Disconnect the green wire, as it should only be connected for programming purposes.
What does SIG on the status line of my ICS GPS mean?
If 'SIG' appears on the status line of your ICS GPS, it indicates a signal fault. This could be due to NAVTEX stations transmitting carrier without modulation or local interference. If it's a short occurrence, it is probably not a problem. If the symbol persists, check for receiver errors or interference from nearby equipment by turning off devices like battery chargers until the SIG indicator disappears.
What to do if no NAVTEX messages are received on my ICS GPS?
To troubleshoot why no NAVTEX messages are being received on your ICS GPS, check for 'SIG' or 'ERR' on the status line, and verify the sensor's placement.
Power| voltage range | 10.8V to 15.6V |
|---|---|
| standby power consumption | 1.5 W at 12V |
| printing power consumption | 2.5 W at 12V |
Operating Environment| operating temperature range | 0 to +40°C |
|---|---|
| storage temperature range | -20 to +55°C |
| humidity | 0 to 95% |
Weight and Dimensions| weight without cable | 1200 g |
|---|---|
| paper roll width | 80mm |
| paper roll length | 20m |
Crucial safety precautions for operating the ICS NAV6.
Highlights the capabilities and components of the ICS NAV6 system.
Explanation of the ICS NAV6 keypad layout and display elements.
How to store, filter, and select NAVTEX messages and stations.
Detailed guide to using the NAVTEX mode, including views and settings.
Description of various display views available in Navigate mode.
Configuration options for display, NAVTEX, and navigation settings.
Guides for upkeep, fault resolution, and alarm management.
Technical data, physical dimensions, and electrical requirements.
Lists of NAVTEX stations and message type codes.
To Next Page
