ICT KT-LCD7C - C10 Automatically Restore Factory Setting

ELECTRIC BICYCLE METER KT—LCD7C Product User Manual
- 26 -
C9 value
Startup password setting
0
Function off
1
Function on
When C9 setting is 1, press button (SW), indicating that the password function
is startup, and then enter the password settings interface, three password setting columns
flash.
Password Setting Interface
The password setting is done sequentially from left to right, press button to
confirm after each setting and enter next setting. Password setting range is 000-999, press
button (UP) or button (DOWN) for selection.
Please note：If you forget your password, the parameters can only be copied (see
parameter copy) by data source meter prier to be decoded.
After finishing C9 parameter setting, press button (SW) to save the current set
values and enter C10 parameter setting interface.
○ C10 Automatically Restore Factory Setting
Enter C10 parameter setting interface, C10 parameter column flashes.
C10 parameter setting interface
C10 is automatic restore factory settings, the default is n, and the setting can be n, or y,