IDEAL Logic Code Combi ES26 - Fault Codes and Actions; Fault Codes


Ideal Logic Code Combi ES -
Installation and Servicing
gENERaL
INTRODUCTION
 Logic Code Combi Es range of boilers are wall mounted,
full sequence, automatic spark ignition, low water content, fanned


DHW cold supply prior to being fully heated in the normal plate

Note. Due to the high efciency of the boiler a plume of water
vapour will form at the terminal during operation.
Central heating (CH) output is fully modulating with a range of:
 
 
 
Instantaneous domestic hot water (DHW) output is also fully
modulating with a maximum of :
 
 
 

exchanger, diverter valve, circulating pump, pressure gauge,







- Automatic bypass
- Boiler frost protection
 









OpERaTION


When there is a demand for CH, the heating system is supplied
at the selected temperature of between 45
o

o
C, until

via the diverter valve to the plate heat exchanger to supply a
nominal DHW draw-off of
 
o

 
o

 
o





At a low DHW draw-off rate the maximum temperature is limited

o


gives detailed information on the boiler status when operating,
and performance of key components to aid commissioning and

saFE haNDLINg

installation site, remove it from its packaging base and during

may include the use of a sack truck and involve lifting, pushing


Operatives should be knowledgeable in handling techniques
when performing these tasks and the following precautions
should be considered:
 
 
 

During all manoeuvres and handling actions, every attempt
should be made to ensure the following unless unavoidable and/

 
 
 
 
 
 
 