17
INsTaLLINg ThE FLUE
FITTINg FLUE ThROUgh ThE WaLL
Note. If the 2 location marks are not visible then the ue is not
pulled back far enough to obtain the correct seal. If the 1st location mark has passed the face of the wall the ue has been
pulled to far back and the outer wall seal will have been dislodged from its mounting and will need to be retted.
less than 50% of the length of the ue is internal the ue should be tted from outside.
FITTINg ThE TURRET
Ensure lip of wall seal is positioned
To Next Page
Loading...
