Care MUST be taken to ensure the correct holes are drilled.
1.
2.
155mm200mm if using a stand-off
3. Mark the following on to the wall:
a
b.
4.
10
WaLL MOUNTINg TEMpLa TE
11
pREpaRINg ThE W aLL
IMpORTaNT.
Ensure that, during the cutting operation, masonry falling
outside of the building does not cause damage or personal
1.
Both wall faces immediately around the cut hole should be
2.
3.
(one at each side, in any of the 3 holes provided at each
13
MOUNTINg ThE BOILER
1. Ensure the plastic plugs are removed from both the CH
Caution: water may discharge from open pipes.
2.
introduction section for safe handling advice) locating it over
12
FITTINg ThE WaLL MOUNTINg pLa TE
V - See Diagram in
Frame 1
Extended centre line
155
(200)
To Next Page
Loading...
