IP NETWORK TEST - Ping
Ping is a standard network debugging tool used for testing if the connected IP camera
or other network equipment’s Ethernet port is working normally and the IP address is
correct.
TOOLS >> Network Tool >> Ping
Connect a network cable to the LAN port and click the icon to open the PING
tool. You can set your LOCAL (native) IP address, Remote IP address (e.g. IP camera),
Packet count, Packet Size, Packet delay time and Timeout. Press “Start” to start
pinging. If the IP camera or network device is not configured properly or not plugged
in, it will say “Destination host unreachable,” or have 100% packet loss. If the tester
connects to the device, the send and receive packets will have a 0% packet loss.
To Next Page
Loading...
