IDEC MICROSmart FC6A Series User Manual

FC6A S ERIES MICROS MART U SER ’ S M ANUAL FC9Y-B1722 6-37
6: D EVICES
■ D8120, D8121: HMI Module Information
HMI module type information is written to these registers.
The allocation of information (bit assignment) is as follows.
The system software version displays the version of the software written to the device.
For details on the type IDs and statuses, see "List of Type IDs and Status" on page 6-49.
■ D8122 to D8127: Cartridge Slot Information
Cartridge Slot 1 to 3 information is written to these registers.
The allocation of information (bit assignment) is as follows.
D8122, D8123 = Cartridge Slot 1 Information
D8124, D8125 = Cartridge Slot 2 Information
D8126, D8127 = Cartridge Slot 3 Information
For details on the type IDs and statuses, see "List of Type IDs and Status" on page 6-49.
0 (00): The signal is on when the FC6A Series MICROSmart is set to run and off when stopped.
While running, the signal is always on regardless of transmitting or receiving data. Set this value when it is
necessary to indicate the run status.
1 (01): Always off.
2 (10): Set this value when performing flow control for received data. The signal is on when data from the
connected device can be received.
The signal is off when data cannot be received.
3 (11): The operation is the same as the setting "0".
Port 30
Port 31
Port 32
Port 33
D8734
Bit
15
Bit
0
Bit
7
Bit
8 12 3 456
Running RunningStopped
DTR signal
ON
OFF
Not possible Not possiblePossible
DTR signal
ON
OFF
Receive
Status
Type ID
D8120
Reserved
System Software Version
D8121
Bit
15
Bit
0
Bit
7
Bit
8
12 34 5 6 910 1112 13 14
D8122, D8124, D8126
D8123, D8125, D8127
Status Type ID
Reserved System Software Version
Bit
15
Bit
0
Bit
7
Bit
8
12 34 5 6 910 1112 13 14
Bit
15

IDEC MICROSmart FC6A Series Specifications

General

Brand	IDEC
Model	MICROSmart FC6A Series
Category	Computer Hardware
Language	English