11: SD M
EMORY
C
ARD
11-22 FC6A S
ERIES
MICROS
MART
U
SER
’
S
M
ANUAL
FC9Y-B1722
SD Memory Card Configuration Dialog Box
Use the SD Memory Card Configuration dialog box to configure the parameters required to create the autoexec.ini file, ZLD
file, and files for MQTT Basic Settings.
(1) button
Click this button and select the file to import.
Note: Import mqtt_basic_settings.ini is valid only if the Specify with SD memory card check box is selected on the MQTT Settings dialog
box.
■ General Tab
On the General tab, configure the settings to create the necessary folder and files for Action.
(2) Action
Download
This parameter can be set from the following three targets.
Upload
Uploads the ZLD file from the CPU module.
For this setting, specify "upload" in "loading_direction" key under the [COMMON_SETTING] section in the autoexec.ini file.
Import autoexec.ini : Restores the contents of the selected autoexec.ini file.
Import mqtt_basic_settings.ini : Restores the contents of the selected mqtt_basic_settings.ini file.
Target Description
ZLD Project
Downloads a ZLD file to the CPU module.
For this setting, specify "download" in "loading_direction" key under the [COMMON_SETTING] section in the
autoexec.ini file.
MQTT Basic Settings Downloads files for MQTT Basic Settings to the CPU module.
All Downloads a ZLD file and files for MQTT Basic Settings to the CPU module.
To Next Page
Loading...
Need help?
General
