FAQ
162
Elevation
• My elevation is off after I backed up my machine.
• Once you move the machine, it's elevation will change. So you need to re-bench the system. Either by touching a reference spot that
you’ve already dug or by catching a rotational laser beam (recommended).
• I'm working in wet material and my machine sinks and/or tilts, my elevation is off after a certain time.
• Once your machine sinks, it's elevation will change. So you need to re-bench the system. Either by touching a reference spot that you’ve
already dug or by catching a rotational laser beam (recommended).
• I would like to change the units of measure to cm, m, feet, inches.
• Go to the Basic Settings. In the "Units" section you can change the units for lengths & slope.
To Next Page
Loading...