FAQ
165
Slope
• I’m working with slope and the system won’t offer me the laser catch symbol.
• Once you enable Slope or Reach, you’ll notice a pop-up window on the right hand side of the screen. It’s purpose is to remind you to
align the cab parallel to the main (slope) axis and click the tiny right hand symbol to confirm. After that you’ll find your laser catch
symbol again.
• I don’t understand the pop-up message on the top right hand corner of the screen after I set a slope.
• Slope always refers to an axis. In order to make the system understand the direction of your main (slope) axis, you need to align the cab
parallel to the main (slope) axis and click the tiny right hand symbol to confirm
• I would like to change the slope units to °, % or X:Y.
• Go to the Basic Settings. In the "Units" section you can change the units for lengths & slope.
• What does the small countdown clock under the alignment button mean?
• Due to the 2D Sensor’s slight drift, you need to realign after a certain time. The countdown shows the time until you need to realign.
• After working with slope or reach for a certain time suddenly a pop-up shows up?
• Due to the 2D Sensor’s slight drift, you need to realign after a certain time. The pop-up indicates the end of a countdown and you need
to realign.
To Next Page
Loading...