Idis DC-D6243HRX - Page 33

Part 1 - Remote Setup
33
- (Region): Select/unselect multiple trip zone
blocks.
-
(Fill): Select/unselect all trip zone blocks.
-
(Polygon): Select/unselect polygon trip zone
blocks by the number of points.
Some models only
Polygon is not supported in IE 10 or earlier.
- Trip Direction: Dene in which direction the
motion has to occur in order for it to be considered
as an event. Select In for movement occurring from
outside the trip zone in and Out for movement
occurring from inside the trip zone out.
• Motion Ignoring Interval: With Motion Ignoring
Interval congured, no event log or notication is
generated for motions detected during a period of
time following a motion detection event.
• Use Ignoring Time: Dene the event ignoring time.
Trip-Zone taking place during the dened time range
will not be assumed as events.
DC-D6233HRX, DC-
D6243HRX only
• Object Calibration: Set the camera’s mounting
position, sensitivity, and the maximum and minimum
size of the object to recognize the object more
accurately.
DC-D6233HRX, DC-D6243HRX only
- Zone: Select the maximum and minimum size of
the object to be measured.
- Mount Type: Set the appropriate value for the
installed camera position. Wall is selected when the
camera is installed on the wall, and Ceiling is when
the camera is installed on the ceiling. Depending on
the installed location, the recognition rate may vary.
- Sensitivity: Select sensitivity for object
measurement.
• Daytime: Specify when daytime starts and ends.
All other times will be assumed as nighttime.
DC-
D3233HRX-N, DC-D3243HRX-N only
- Alarm Out: Select if you wish to generate an alarm
out.
- Send Email: Select if you wish to send an email.
Select the Image Attachment option to attach a
.jpg image of the event detected to the email.
- Remote Callback: Select this option to send a
message to a remote system and then select which
system to send the message to.
• Not supported from the IDIS Web program.
• The camera must be registered to the remote
system in order to use the Remote Callback
feature.
- Audio Alarm: Select this option to generate an
audio alert and then choose an audio le.
- FTP Upload: Select this option if you wish to
upload images to the FTP server.
- Record: Select this option to record video.
Event Action settings must be congured correctly
in order to perform event actions.
• The recognition rate may decrease in low-light
images.