Idis DC-D6243HRX - Object Detection

Part 1 - Remote Setup
38
recognize the object more accurately.
- Zone: Select the maximum and minimum size of
the object to be measured.
- Mount Type: Set the appropriate value for the
installed camera position. Wall is selected when the
camera is installed on the wall, and Ceiling is when
the camera is installed on the ceiling. Depending on
the installed location, the recognition rate may vary.
- Sensitivity: Select sensitivity for object
measurement.
• Event Action: Select a loitering event alert action.
- Alarm Out: Select if you wish to generate an alarm
out.
- Send Email: Select if you wish to send an email.
Select the Image Attachment option to attach a
.jpg image of the event detected to the email.
- Remote Callback: Select this option to send a
message to a remote system and then select which
system to send the message to.
• Not supported from the IDIS Web program.
• The camera must be registered to the remote
system in order to use the Remote Callback
feature.
- Audio Alarm: Select this option to generate an
audio alert and then choose an audio le.
- FTP Upload: Select this option if you wish to
upload images to the FTP server.
- Record: Select this option to record video.
• Event Action settings must be congured
correctly in order to perform event actions.
• The recognition rate may decrease in low-light
images.
Object Detection
Select Object Detection and congure object detection
settings. With object detection event enabled, an event
is considered when an object is detected in a set zone.
DC-D6233HRX, DC-D6243HRX only
• Area: Click Setup and dene the object detection
area using blocks.
-
(Select)/ (Unselect): Enable/disable object
detection blocks.
-
(Single Block): Select/unselect object detection
blocks individually.
-
(Zone): Select/unselect multiple object detection
blocks.
-
(All): Select/unselect all object detection blocks.
-
(Polygon): Select/unselect polygon object
detection blocks by the number of points.
Some
models only
Polygon is not supported in IE 10 or earlier.
• Detection subject: Select the type of object to
recognize. (All: all detected objects, human: humans,
car: cars, human or car: humans and cars)
• Ignore Interval: With Object Detection Ignoring
Interval congured, no event log or notication is
generated for object detected during a period of time
following a object detection event.
• Use Ignoring Time: Dene the event ignoring time.
Object detections taking place during the dened
time range will not be assumed as events.Object
Calibration: Set the camera’s mounting position,