Idis DR-6516P - Notification Setup; Schedule; Callback

Part 2 - Conguration
80
Notication Setup
Schedule
Select the + icon at the lower left corner of the screen to
add a notication schedule.
● Day: Add dierent schedules for dierent days of the
week.
● Range: Change the event notication time frame.
● Notify: Select which notications to generate when
an event occurs. Select Mail, LAN 1 through 5, Push,
HTTP, FTP, and/or Summary.
• In order to use the Notication (Callback) feature,
the NVR must be registered on the remote program.
• Select the icon to delete the existing schedule.
● Summary Email Interval: Transmit event summary
emails to a remote destination at specied intervals.
Callback
Congure Callback settings.
Enter the IP address of the receiving server and set
Retry to between 1 and 10 in case of connection failure.
Select the Setup... button at the lower right corner of the
screen to congure Callback Retry Policy.
● Short-Term Retry Policy: Congure short-term policy
to retry a callback event.
– Retry: Number of times to retry a callback event.
– Dwell: Wait time (in seconds) between retry
attempts
● Long-Term Retry Policy
– Use: Congure long-term policy to retry a callback
event.
– Retry: Number of times to retry a callback event.
– Dwell: Wait time (in minutes) between retry
attempts
– Check Interval: Interval time (in minutes) to check
failover.
In a general wired network communication
environment, not a wireless (mobile) /
satellite communication environment where
communications failures are frequent, long-term
retry policies (LTRPs) are not required, except for
particular cases.