10
IDS LCD Keypad User Manual 700-292-01C Issued March 2009
The LCD display will read 'Partial Arm' and will indicate any zones which have been bypassed. One is
able to scroll through the list of bypassed, as well as violated, zones by using the [PANIC] and [MED]
keys.
2.3 How to Stay Arm and Go
(Hold down the [6] key for two seconds until the keypad buzzer sounds)
This is a single key arm function, which allows the user to STAY arm and leave the premises.
If a partition is already stay armed, holding down the [6] key initiates an exit delay, thus allowing the user
to leave the premises without disarming. At the end of the exit delay, the partition will re-arm in the same
stay profile it was armed in before the [6] key was held down.
1. Make sure all zones are clear. Hold down the [6] key until the keypad buzzer sounds. The LCD
screen display will read 'Exit Delay' alongside the partition number being armed. Any zones that
have been bypassed will be displayed on the LCD Display as solid text. Any zones that are
violated will be displayed on the LCD Display as flashing text. Use the [PANIC] and [MED] keys
to scroll through zones which have been bypassed or violated. The keypad buzzer will sound for
the duration of the exit delay. Only leave via a designated exit route.
2. At the end of the exit delay, the ARM indicator will come on and the display will read 'Stay Arm'.
All stay zones will be bypassed.
2.4 Key-Switch or Remote Arming (If fitted)
1. Ensure that the LCD display reads 'Ready to arm' before leaving.
2. Leave and close the door (remembering to lock!)
3. Activate the remote or the key-switch. A remote can be used to Stay Arm or Away Arm.
4. The alarm will arm in the away mode.
NOTE:
If a remote control is used it is advisable to have the siren toot on arm function enabled. This provides
verification that the system has armed.
2.5 Auto Arming
The panel may be programmed to arm automatically at a preprogrammed time. Should the premises be
occupied at the time of auto arming, a valid [USER CODE] entered during the pre-arm delay will
terminate the arming sequence. The pre-arm delay is signalled by an exit beep.
3. Disarming the Control Panel
3.1 How to Disarm with a User Code
[#] + [USER CODE]
To disarm the system, enter [#] followed by a valid [USER CODE].
1. Enter the premises through a designated entry route. Entering via any other route will cause an
alarm.
To Next Page
Loading...
Need help?
General
