21
IDS LCD Keypad User Manual 700-292-01C Issued March 2009
8.3.5.11 Fire Code
(Not applicable to the IDS 1224 & IDS 816)
If enabled ,this option allows reporting of a Fire Code. In the event that this code is reported, all fire doors
will be automatically opened.
8.3.6 Option 5 - Assign User Code to Partitions
Hold [*] + [Master Code] + [*] + [5] + [*] + [User Code] + [*] + [Partition Number] + [*]
1. Enter the User Program Mode as per steps 1 - 4 of (8.2).
2. IDS 816 Panel
When prompted for the 'Menu Option' press the [5] key followed by the [*] key to select
programmable option 5.
IDS 1632 & IDS 1224 Panels
Menu option 0 - 'Add User' is displayed on the LCD Screen by default. To select menu option 5 -
'Partitions', press the [5] key or alternatively use the [PANIC] or [MED] keys to scroll
through the list of programmable options until you reach Menu Option 5. Press the [*] key to
confirm your selection.
3. The ARM indictor will flash and the LCD prompt reads 'Enter User Code'.
4. When prompted for the 'User Code‟ enter the [USER CODE] followed by the [*] key.
5. The partitions to which the [USER CODE] is assigned are indicated by Options 1 or 2 in the
case of the IDS 816, Options 1 - 4 in the case of the IDS 1224 or Options 1- 8 in the case of the
IDS 1632. If the user is assigned to partition 1, there will be a [Y] next to Option 1 and the user
can thus arm and disarm partition 1. If the user is assigned to partition 4, there will be a [Y] next
to Option 4. It is possible to program codes to arm / disarm any combination of the available
partitions.
6. To select which partitions the [USER CODE] may arm or disarm, toggle options by entering the
[PARTITION NUMBER] followed by the [*] key. One may also use the [PANIC] and [MED]
keys to scroll through the partitions.
7. Repeat step 6 until the User Code has been assigned to the correct partition(s).
8. Press the [#] key to edit another User Code's partitions.
9. Press [#] twice to exit program mode.
8.3.7 Option 6 - Assign User Code to Doors
(Not applicable to the IDS 1224 & IDS 816)
Hold [*] + [Master Code] + [*] + [6] + [*] + [User Code] + [*] + [Door Number] + [*]
1. Enter the User Program Mode as per steps 1 - 4 of (8.2).
2. Menu option 0 - 'Add User' is displayed on the LCD Screen by default. To select menu option 6 -
'Doors', press the [6] key or alternatively use the [PANIC] or [MED] keys to scroll through the list
of programmable options until you reach Menu Option 6.
3. To select programmable option 6, press the [*] key. The ARM LED will flash.
4. When prompted for the 'User Code' enter the [USER CODE] followed by the [*] key.
5. The doors to which the [USER CODE] can be assigned are indicated by Options 1 - 14. To
scroll through the list of options use the [PANIC] or [MED] keys. Use the [*] key to toggle
between [Y] and [N]. Alternatively press the door number you wish to select.
To Next Page
Loading...
Need help?
General
