Explanation of User Code Properties
8.3.5.1 Master User
When assigned to a user, this property allows the user to act as a Master User.
8.3.5.2 Duress Code
This is a special 4 (default) or 6 digit user code (check the code length with your installer) and
should only be used in the unique situation where an intruder forces one to disarm the system
"under duress".
When the [DURESS CODE] is entered, the control panel disarms normally - however a DURESS
REPORTING CODE is transmitted to the monitoring company to inform them that you have been
forced to disarm the control panel by an intruder.
It is advisable to choose a code that can be easily remembered by all family (or staff) members.
8.3.5.3 Maid's Code
This code may be used to limit access to the premises. A maid's code will only disarm the system if the
same code was used for arming. If armed with a code other than this code, the system will view an
attempt to disarm using a maid's code as an invalid entry. Any valid user code will disarm the system if it
has been armed with a maid‟s code.
8.3.5.4 Global Arm / Disarm Code
(Not applicable to the IDS 1224 & IDS 1632)
This code when entered will either arm or disarm the partitions assigned to that user depending on their
status. If both partitions are disarmed, entering a global code will arm both partitions. If both partitions are
armed, entering a global code will disarm them. In the case where one partition is armed and the other
To Next Page
Need help?
General
