12
IDS LCD Keypad User Manual 700-292-01C Issued March 2009
4.2 How to Un-Bypass a Zone
Hold down [9] + [ZONE NUMBER] + [*] + [#]
1. Enter bypass mode by holding down the [9] key until the keypad buzzer sounds. The power and
arm LED's will be off. All zones will be displayed on the screen with either a [Y] or a [N] alongside
the zone.
2. [Y] indicates that the zone has been bypassed, whilst [N] indicates that the zone has not been
bypassed.
3. Press the number corresponding to the currently bypassed zone, then press the [*] key.
Alternatively use the [PANIC] or [MED] keys to scroll through the zones.
4. Press the [#] key to exit User Program Mode.
5. Emergency Alarms
5.1 Fire Alarms
[F]
(Hold down the [F] key for two seconds until the keypad buzzer sounds)
If the [F] key is pressed until the keypad beeps (approximately 2 seconds) a FIRE ALARM
condition will be activated. The Display reads 'Alarm!' alongside the relevant partition.
The FIRE ALARM CONDITION may also be triggered by a smoke detector connected to an
appropriately programmed zone.
The siren will sound on and off repeatedly if programmed and the FIRE REPORTING CODE will
be transmitted to the monitoring company.
To silence the siren enter a valid [USER CODE].
5.2 Panic Alarms
[P]
(Hold down the [P] key for two seconds until the keypad buzzer sounds)
If the [P] key is pressed until the keypad beeps (approximately 2 seconds) a PANIC ALARM
condition will be activated. The Display reads 'Alarm!' alongside the relevant partition number.
A PANIC ALARM may also be activated using any FIXED PANIC button or a REMOTE PANIC
button (if installed).
If the audible panic option has been selected, the siren will sound. A PANIC ALARM will be
transmitted to the monitoring company.
To silence the siren, enter a valid [USER CODE].
Press the [P] key only in an emergency situation which requires response by emergency
personnel.
To Next Page
Loading...
Need help?
General
