IEI MiniMax 3 Installation/Programming Manual Section 2: Installation
2.16 Power up the System
Plug the transformer into a grounded 110 VAC electrical outlet. You should now have power to your system. Check the power status
by checking the following:
On the Backplane:
• LED 1 should be lit - This indicates that AC Power is present
• LED 3 should be lit - This indicates that DC Power is available on the Backplane
On the Max 3 Module:
• LED 1 should be lit - This indicates that the Max 3 Module is receiving power and functioning
• LED 4 should be lit - This indicates that the Front End Reader is receiving power
If the above requirements are met the system is now powered up and ready for programming and operation.
If the above requirements are not met see the Troubleshooting Section.
Document #: 6055672, Rev 1.0 D1c Page 27 of 48
To Next Page
Loading...
Need help?
General