Table of Contents IEI MiniMax 3 Installation/Programming Manual
Table of Contents
Section 1: System Features and Specifications........................................................ 5
1.1 System Features...........................................................................................................................5
1.2 Specifications................................................................................................................................6
1.3 System Defaults............................................................................................................................6
1.4 Max 3 Door Control Module Diagram...........................................................................................7
1.5 Backplane Diagram.......................................................................................................................8
Section 2: Installation................................................................................................... 9
2.1 Check the Packing List..................................................................................................................9
2.2 Mount the Enclosure.....................................................................................................................9
2.3 Ground the Unit...........................................................................................................................10
2.4 Connect the RS-485 Cable from the Module to the Backplane..................................................11
2.5 Wire an Electric Door Lock to the Main Relay of the Max 3 Module.......................................... 12
2.5.1 Installing a Diode to Prevent Electrical Kickback from Lock – DC Locks Only................... 13
2.5.2 Installing an MOV to Prevent Electrical Kickback from Lock – AC Locks Only...................13
2.6 Connect a Secured Series Front End (SSFE) Reader to the Door Control Module...................14
2.7 Connect the Primary Wiegand Front End Reader (IN Reader)..................................................15
2.8 Connecting a Secondary Wiegand Front End Reader (OUT Reader)........................................16
2.9 Wire a Request to Exit (REX) device and Door Contact.............................................................17
2.10 Wire the Alarm Shunt Relay......................................................................................................18
2.11 Wire the Door Ajar Relay..........................................................................................................19
2.12 Wire the Forced Door Relay......................................................................................................20
2.13 Network the MiniMax 3..............................................................................................................21
2.13.1 Connect the MiniMax 3 Backplane Directly to a PC..........................................................21
2.13.2 Connect Multiple Backplanes Together.............................................................................22
2.13.3 Connect the SEG-M to the MiniMax 3 (LAN/WAN Connection)........................................23
2.13.4 Connecting the SEG-1 to the MiniMax 3 (LAN/WAN Connection)....................................24
2.14 Installing a Tamper Switch........................................................................................................25
2.15 Complete Connections Between the 16.5 VAC Transformer and Backplane.......................... 26
2.16 Power up the System................................................................................................................27
Section 3: Programming............................................................................................ 28
3.1 Programming Methods................................................................................................................28
3.2 Entering Program Mode and Changing the Master Code...........................................................29
3.2.1 Entering Program Mode.......................................................................................................29
3.2.2 Changing the Master Code..................................................................................................29
3.2.3 Programming a Supervisor Code........................................................................................29
3.3 Changing the Door Number........................................................................................................30
3.4 Changing the Main Relay Time...................................................................................................30
3.5 Setting the Time and Date..........................................................................................................30
3.6 Programming Users....................................................................................................................31
3.6.1 User Types...........................................................................................................................31
3.6.2 Programming a “Code Only” User.......................................................................................32
3.6.3 Programming “Card Only” Users by Presentation..............................................................32
3.6.4 Programming 26-Bit “Card Only” Users without Presentation.............................................32
3.6.5 Programming “Code AND Card” Users...............................................................................33
3.6.6 Programming “Code or Card” Users....................................................................................33
3.6.7 Programming 26-Bit “Card Only” Users via Batch Entry without Presentation................... 33
Page 2 of 48 Document #: 6055672, Rev 1.0 D1c
To Next Page
Loading...
Need help?
General