IFM Electronic O1D155 - 9 Operating Modes; 9.1 Run Mode; 9.2 Display Mode; 9.3 Object Reflectivity

13
UK
9 Operating modes
9.1 Run mode
The run mode is the normal operating mode�
After power on the unit is in the Run mode� It carries out its monitoring function
and generates output signals according to the set parameters�
The display indicates the current distance, the yellow LEDs signal the switching
status of the outputs�
9.2 Display mode
Indication of the parameters and the set parameter values�
► Press [MODE/ENTER] briefly�
> Unit goes to the Display mode� Internally it remains in the operating mode�
The set parameter values can be read�
► To scroll through the parameters, press [MODE/ENTER] briefly�
► To display the respective parameter value, press [SET] briefly�
> After 15 s the unit returns to the Run mode�
9.3 Object reflectivity
Display of the object reflectivity (formerly: align mode)�
► Press [SET] in the Run mode�
> The unit displays an orientation value for the object reflectivity
(e�g� +100 corresponds to a white object, +020 corresponds to a grey object)�
9.4 Programming mode
Setting the parameter values → 10.1 Parameter setting in general