Configuration
2014-04-15 51
5.5 Configuration File
The KVM Extender contains a configuration file (Config.txt) to set specific
parameters and to read out device and video information. You can find it
on the flash drive of the KVM Extender. The flash drive can be opened by
a mini USB connection to a computer.
The configuration file can be edited with all common text editors.
After setting a parameter, the KVM Extender needs to be restarted.
To ensure correct identification and acceptance of the parameters, the
start command #CFG has to be written into the first line of the Config.txt
file.
5.5.1 Parameters for CPU Units
You can write the following parameters into the configuration file of a CPU
Unit.
DDC-Management
Parameter Function
ENAHPDET Enable hotplug switch for K238-5x series
LOCKEDID Activate DDC write protection
Digital-Audio
Parameter Function
SRC32000
Activate sample rate conversion, sample rate
32 kHz (only with digital audio upgrade module)
SRC44100
Activate sample rate conversion, sample rate
44,1 kHz (only with digital audio upgrade
module)
SRC48000
Activate sample rate conversion, sample rate
48 kHz (only with digital audio upgrade module)
SRC96000
Activate sample rate conversion, sample rate
96 kHz (only with digital audio upgrade module)
SRC_NONE
Deactivate sample rate conversion (only with
digital audio upgrade module)
To Next Page
Loading...
Need help?
General
