EasyManua.ls Logo

illy Y5 MILK - Installation of the Machine

illy Y5 MILK
308 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
- Do not carry or pull the co ee machine by the cord.
- To reduce the risk of injury, do not drape cord over the counter
top or table top where it can be pulled on by children or tripped
over unintentionally.
- In case of  re, extinguish with carbon dioxide (CO
2
). Do not use
water or powder extinguishers.
Never obstruct the vents on the base of the machine.
Installation of the machine
- Read the instructions carefully.
- Do not install the machine in an area where the temperature may
reach 0°C/32°F or lower (if water freezes, the appliance may be
damaged) or higher than 40°C/104°F.
- Check that the mains electric voltage corresponds to the require-
ments indicated on the machine data plate. Connect the machine
only to a properly grounded power outlet with a minimum rating
of 6A for models powered at 230Vac, and 15A for models po-
wered at 120Vac.
- If the plug and the outlet are not compatible, have the plug
replaced with a proper one by an authorized service center.
IMPORTANT WARNINGS
MESURES IMPORTANTES DE SÉCURITÉ
aux personnes.
- Avant de débrancher l’appareil, s’assurer que l’interrupteur général
est sur « 0 » (Fig.1).
- Ne pas retirer la  che en tirant sur le câble et ne pas la toucher avec
les mains si celles-ci sont mouillées.
- Ne pas déplacer ou tirer l’appareil en le tenant par le cordon.
- Pour prévenir le risque de blessures, ne pas laisser tomber le câble
du plan de travail ou de la table car les enfants pourraient le tirer
ou trébucher involontairement.
- En cas d’incendie, utiliser des extincteurs à anhydride carbonique
(C0
2
). Ne pas utiliser d’eau ou d’extincteurs à poudre.
- Ne jamais bloquer les grilles d’aération se trouvant sur la base de
l’appareil.
Installation de lappareil
- Lire attentivement les instructions.
- Ne jamais installer la machine dans un milieu pouvant atteindre
une température inférieure ou égale à 0°C (si l’eau gèle, l’appareil
peut s’endommager) ou supérieure à 40°C.
- Véri er que la tension du réseau électrique corresponde bien à celle
indiquée sur la plaque signalétique de l’appareil. Ne brancher l’appareil
qu’à une prise de courant ayant un débit minimal de 6 A pour les

Table of Contents

Related product manuals