13. IDENTIFICATION PLATES
WARNING:
Never remove the identification nameplates provided on the generator, control unit and collimator cone.
NOTE: This section applies only to models RX DC REF: I3PV****S
(Character * can be any alphanumeric value)
Control unit (MAIN NAMEPLATE).
The nameplate is located beside the main switch
Data given on plate:
- Name and address of the manufacturer.
- Brand and model of equipment.
- Rated voltage.
- Type of current.
- Rated frequency.
- Maximum current absorbed.
- Serial number.
- Month and year of manufacture.
- Approval marks.
- Symbol required by standards.
NOTE: This section applies only to models RX DC REF: I3PV****M
(Character * can be any alphanumeric value)
Control unit (MAIN NAMEPLATE).
The nameplate is located beside the main switch.
Data given on plate:
- Name and address of the manufacturer.
- Brand and model of equipment.
- Rated voltage.
- Type of current.
- Rated frequency.
- Maximum current absorbed.
- Serial number.
- Month and year of manufacture.
- Approval marks.
- Symbol required by standards.
X-ray head.
The nameplate is located on the lower cover at the back of
the x-ray head.
Data given on plate:
- Name of manufacturer.
- Name of equipment.
- Technical specifications.
- Model and x-ray tube serial number.
- Equipment serial number.
- Month and year of manufacture.
- Symbol required by standards.
To Next Page
Loading...
