14. TIMES/SENSITIVITY CHARTS
When using the x-ray unit, in conjunction with Zen-X or X-Pod, it is recommended to use the default value of
sensitivity.
When using the x-ray unit, in conjunction with digital sensors (CMOS / CCD), phosphors or films, you need to find the
appropriate exposure time in relation to the image that you want to obtain. Once identified this time for a specific
combination of tooth and patient size, you can set the sensitivity parameter in accordance with the exposure time
found (procedure described in paragraph 5.4).
NOTE: This section applies only to models RX DC REF: I3PV*6***
(Character * can be any alphanumeric value)
Collimator (focus-skin distance)
Upper incisors/front “bitewing”
Upper canines/bicuspids/rear “bitewing”
NOTE: This section applies only to models RX DC REF: I3PV*7***
(Character * can be any alphanumeric value)
Collimator (focus-skin distance)
Upper incisors/front “bitewing”
Upper canines/bicuspids/rear “bitewing”
* = Default settings
A = Large size
B = Small size