Need help?Do you have a question about the Image Sensing Systems RTMS Echo and is the answer not in the manual?
General| Brand | Image Sensing Systems |
|---|---|
| Model | RTMS Echo |
| Category | Radar |
| Language | English |
Details on voltage and current requirements for powering the RTMS Echo.
Illustrates the pinout configuration for the RJ-45 connector used by the RTMS Echo.
Details the CITEL MJ8-POE-B as the recommended surge suppressor.
Details the COSEL SNR-10-23-DT as the recommended line noise filter.
Block diagram showing connections with separate surge suppressors.
Illustration showing the earth ground connection setup.
Diagram illustrating how surges are channeled into the earth ground.
Provides recommended mounting heights and tilt angles based on zone distances.
A table detailing mounting height and tilt for various zone distances.
Crucial safety information before proceeding with sensor installation.
Lists the provided and not-provided equipment for sensor installation.
Details recommended mounting heights based on setback and lanes.
Steps for attaching the mounting bracket and securing the RTMS Echo unit.
Guidance on adjusting the sensor's roll and tilt for optimal aiming.
Introduction to operations and adjustments after installation.
Procedure for logging into the RTMS Echo via its web interface.
Addresses inaccuracies where counts are too high in one zone and too low in another.
To Next Page
