Why does my Immergas VICTRIX OMNIA Boiler overheat frequently?
If your Immergas Boiler frequently trips the overheating safety device thermostat, it might be due to a lack of water, poor water circulation, or a blocked circulating pump. Check the pressure gauge to ensure the system pressure is within established limits. Also, verify that the radiator valves are open and the pump is working correctly.
What to do if my Immergas VICTRIX OMNIA Boiler has repeated ignition blocks?
If your Immergas Boiler experiences repeated ignition blocks, it could be due to no gas or a clogged condensate drain. Check that there is pressure in the network and the gas adduction cock is open. Restore the function of the condensate drain, and ensure the condensate has not affected combustion components, the fan, or the gas valve. Also, check the function of the condensate sensor.
Why does my Immergas VICTRIX OMNIA Boiler make abnormal noises?
Abnormal noises in the system of your Immergas Boiler are caused by air. Check the opening of the cap of the air vent valve. Make sure the system pressure and expansion vessel pre-charge values are within the set limits. The factory-set pressure values of the expansion vessel must be 1.0 bar, the value of system pressure must be between 1 and 1.2 bar.
Why is my Immergas VICTRIX OMNIA Boiler combustion irregular or noisy?
If you notice irregular combustion or noisiness in your Immergas Boiler, the burner might be dirty, the primary heat exchanger clogged, the combustion parameters incorrect, or the intake-exhaust terminal not correctly installed. Check these components.
Why does my Immergas VICTRIX OMNIA condensation module make abnormal noises?
Abnormal noises in the condensation module of your Immergas Boiler are caused by air. Use the manual air vent valve to eliminate any air present in the condensation module. When the operation has been performed, close the manual vent valve.
Why is the ignition of my Immergas VICTRIX OMNIA not optimal?
The first ignitions of the burner of your Immergas Boiler (after calibration) may not be optimal, but the system automatically adjusts the burner ignition until the best ignition conditions are found.
How to fix a seized rotor in my Immergas Boiler?
If the rotor of your Immergas Boiler is seized, carefully act on the screw in the middle of the head to manually release the crankshaft; circulation starts up immediately after the rotor is re- leased and the LED switches from red to green after about 10 seconds.
What to do if my Immergas VICTRIX OMNIA has low power supply voltage?
If your Immergas Boiler has a low power supply voltage, wait for it to rise. When the pump restarts, the LED will turn green again after about one second. Note that the flow rate decreases as the supply voltage decreases.
What to do if Immergas VICTRIX OMNIA frequently trips the overheating safety device thermostat?
If you frequently experience trips of the overheating safety device thermostat function in your Immergas Boiler, ensure the system pressure is within established limits by checking the pressure gauge. Also, verify that the radiator valves are open and the pump is functioning correctly. This issue may arise from a lack of water in the appliance, poor water circulation, or a blocked pump.
Why is my Immergas VICTRIX OMNIA making abnormal noises?
If you notice abnormal noises in your Immergas Boiler system, it might be due to air present in the system. Check the opening of the cap of the air vent valve. Ensure the system pressure and expansion vessel pre-charge values are within the set limits. The factory-set pressure values of the expansion vessel must be 1.0 bar, and the system pressure should be between 1 and 1.2 bar.
To Next Page
General